SIGLENT SDS1000D Manual de servicio descargar pdf (Pagina 20)

Service Manual

USB Device Test

Purpose: Test if the USB Device interface works normally through EasyScope for SDS1000D

series oscilloscope.

Tools：

● An Unit SDS1000D digital oscilloscope

● A computer with USB interface

● A standard USB cable(Type AB)

● EasyScope software for SDS1000D series

Steps：

1．Install the EasyScope to computer.

2．Connect the oscilloscope with PC using an USB cable and install the driver program step by

step following the instruction.

Picture 3-3 connecting the USB Device interface

3．Run EasyScope ,then click “Connect”, if successful, the two point lamps at the top right

corner of the software will be changed from red to green.; if failed, a prompt message will be

appeared as below.

Picture 3-4 USB Device connect failed

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Sin comentarios

SIGLENT SDS1000D Manual de servicio Pagina 20