SIGLENT SDS1000D Manual de usuario descargar pdf (Pagina 137)

129

Chapter 4

prompting messages and troubleshooting

4.1 Prompting messages:

■

Trig level at limit! : Mention you that the trigger Level is at a limit when you

turn the Trig level knob.

■

Horizon position at limit! : Mention you that the horizontal position is at a

limit when you turn the horizon position knob.

■

Volts/Div at limit! : Mention you that the vertical voltage have already

touched the Min 2MV/div or the Max 5V/div.

■

Volts position at limit! : The system would display this information when

the vertical position is at a limit.

■

Sec/Div at limit! : Prompts that the Volts/Div is at full range while turning the

vertical scale knob.

■

Holdoff time at limit! : Turn the “Universal” knob when holdoff time has

been to max or min value, now the system will clew this information.

■

Functions isn’t useable! : Under several special modes, the some

functions could not be running.

■

No signal! : The system would clew this information when the signal could

not match the auto set condition. (Using in the auto set)

■

Adjust at limit! : You could adjust the pulse width by the universal knob till

the pulse width has reached min20.0ns or max 10.0s.

■

Location Empty! : If you have no stored waveforms or setups on some

location, the screen will display this information when you press the “Recall”

button on this location.

■

USB Flash Drive Plug In! : This information will appear when you invert the

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 153 154

Sin comentarios

SIGLENT SDS1000D Manual de usuario Pagina 137