SIGLENT SDS1000D Manual de usuario descargar pdf (Pagina 91)

SAVE/RECALL SETUP

■

Save Setups to Device：

：：

： The complete setup is stored in nonvolatile memory. When

you recall the setup, the oscilloscope will be in the mode from which the setup was

saved.

The oscilloscope saves the current setup if you wait three seconds after the last change

before you power off the oscilloscope. The oscilloscope recalls this setup the next time

you apply power.

Table 2-41 Save setup to device function menu:

Option Setting Introduction

Type Setups Menu for the Storage/Recall setting in the

oscilloscope

Save to Device Save setup to the oscilloscope’s internal

memorizer.

Setup No.1 to No.20

Press the “Setup” option button or turn the

“universal” knob to select storage position.

Save Accomplish the storage

Recall Recall the storage in the “Setup” operation

Picture 2.12-6

Save setups to the oscilloscope’s internal memorizer, follow next steps:

For example: Save setup that set waveform display type to “Dots” to internal memory.

1）. Press the “SAVE/RECALL” button to enter the “SAVE/RECALL” menu.

2）. Press the “Type” option button to select “setups”.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 153 154

Sin comentarios

SIGLENT SDS1000D Manual de usuario Pagina 91