SIGLENT SDS1000D Manual de usuario descargar pdf (Pagina 79)

parallel cursors to measure voltage or time. You can move the cursor by

turning the “Universal” knob. Before using cursors, you should make sure that

you have set the signal source as the channel for measuring.

■ Voltage Cursor: Voltage cursors appear as horizontal lines on the display

and measure the vertical parameters.

■ Time Cursor: Time cursors appear as vertical lines on the display and

measure the horizontal parameters.

■ Cursor Moving: Use the “universal” knob to move cursor1 and

cursor2 .They could be moved when the corresponding cursor option are

selected, and cursor value will display on the bottom left and top left of the

screen when you move the cursor.

To do manual cursor measurements, follow these steps:

1. Press CURSOR button to enter the cursor function menu.

2. Press the “Cursor Mode” option button to select “Manual”.

3. Press the “Type” option button to select “Voltage” or “Time”.

4. Press the “Source” option button to select “CH1”, “CH2”, “CH3”,

“CH4”,“MATH”, “FFT”, “REFA” ,“REFB” ,“REFC”, “REFD” according to

input signal channel.

5. Select “Cur A”, turn the “Universal” knob to adjust Cursor A.

6. Select “Cur B”, turn the “Universal” knob to adjust Cursor B.

7. The measurement values are displayed on the top of the left corner:

If the measurement type is set to “Voltage”, the values are:

The value of Cur A: CurA

The value of Cur B: Cur B

The voltage increment between Cursor A and Cursor B: △V

If the measurement type is set to “Time”, the values are:

The value of Cur A: CurA

The value of Cur B: Cur B

The time increment between Cursor A and Cursor B: △T

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 153 154

Sin comentarios

SIGLENT SDS1000D Manual de usuario Pagina 79