SIGLENT SDS1000D Manual de usuario descargar pdf (Pagina 59)

Picture 2.8-8

Operate Instruction:

Follow next steps if you select “Slope trigger”:

1. Input a signal to CH1,CH2,CH3 or CH4.

2. Press the “AUTO” button.

3. Press the “TRIG MENU” button to enter “Trigger menu”.

4. Press the “Type” option button to select “Slope”.

5. Press the “Source” option button to select “CH1” ,“CH2”, “CH3” or “CH4”.

“LEVEL A”, “LEVEL B” or

adjust them at the same

time.

Auto

Use this mode to let the

acquisition free-run in the

absence of a valid trigger; This

mode allows an untriggered,

scanning waveform at 100 ms/div

or slower time base settings.

Normal

Use this mode when you want to

see only valid triggered

waveforms; when you use this

mode, the oscilloscope does not

display a waveform until after the

first trigger.

Mode

Single

when you want the oscilloscope to

acquire a single waveform, press

the “SINGLE ”button.

Set up

Enter the “Trigger setup

menu”(See table 2-14).

Next Page Page 2/2

Return the first page of slope

trigger.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 153 154

Sin comentarios

SIGLENT SDS1000D Manual de usuario Pagina 59