SIGLENT SDS1000D Manual de usuario descargar pdf (Pagina 23)

■

SAVE/RECALL: Press to display the Save/Recall menu. You can use the

Save/Recall menu to save and recall up to 20 oscilloscope setups or waveforms in

internal memory(up to 20 wavefroms) or on a USB memory device(limited by memory

capacity of USB device). You can also use it to recall the default factory settings, to

save waveform data as a comma-delimited file(.CSV), and to save or print the

displayed waveform image.

■

ACQUIRE: Press to display Acquire menu.You can use the Acquire menu to set the

acquisition Sampling Mode( Sampling, Peak Detect, Average).

■

MEASURE: Press to display a menu of measurement parameters.

■

CURSORS: Display the Cursor Menu. Vertical Position controls adjust cursor

position while displaying the Cursor Menu and the cursors are activated. Cursors

remain displayed (unless the “Type” option is set to “Off”) after leaving the Cursor

Menu but are not adjustable.

■

DISPLAY:Press to open the Display menu. You can use the Display menu to set grid

and waveform display styles, and persistence.

■

UTILITY: Press to open the Utlity menu. You can use the Utility menu to configure

oscilloscope features, such as sound , language, counter, etc. You can also view

system status and update software.

■

DEFAULT SETUP: Press to reset the oscilloscope’s settings to the default factory

configuration.

■

HELP: Enter the online help system.

■

AUTO: Automatically sets the oscilloscope controls to produce a usable display of

the input signals.

■

RUN/STOP: Continuously acquires waveforms or stops the acquisition.

Note：If waveform acquisition is stopped (using the RUN/STOP or SINGLE

button), the SEC/DIV control expands or compresses the waveform.

■

SINGLE: Acquire a single waveform and then stops.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 153 154

Sin comentarios

SIGLENT SDS1000D Manual de usuario Pagina 23